Search results
The main ones are that you get more control because you have two fingers on the stick instead of one and that your fingers won't slide off when you're really banging on the sticks. Piro flips, for example, require that you move the right stick (in mode 2) in a circular motion. Do this enough and your fingers start to slide a bit.
That's probably the easiest way to do it. The protocol is a simple PWM signal, and there are options in the QX7 menus where you can take the inputs for some channels from the trainer port and some normally from the sticks.
He flew a ways out then put it in return to home mode and pressed a button that allowed him to control his gimbal while the copter flew home. Ive been reading about the DJI datalink all morning. It would be very cool to program a few waypoints and let the copter fly around while you hold a switch on your radio and control a 3 axis gimbal.
S.BUS/S.BUS2 device setting S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T16SZ. Channel setting and other data can be entered for the S.BUS/S.BUS2 servos or sensors. 1. Connect the S.BUS device and battery you want to set with a 3-way hub or Y-harnesses T16SZ as shown in the figure.
The lower your min_check is configured the lower throttle you can get out of your quad in air mode. If your min_check is set to 1100 and your TX goes down to 1000 that would mean that it is already giving some throttle. I use min_check a bit higher than 1000. I believe something like 1015 or 1020.
Foxeer Predator. UP&DOWN do not work, hopefully future batches will have the firmware flaw addressed. set camera_control_internal_resistance = 99. Predator expects a really low value for DOWN, while the FC can't output lower than 3.3 * R / (R + 9.9 kΩ). Use a resistor of 75-150 Ω to make it work.
People also ask
How much power does a quadcopter need?
Can I move the throttle / pitch stick high?
How much 'direct' motor control is available at full stick angle?
Why do stick commands work?
How do I charge a t16sz transmitter?
How do I charge my Futaba t16sz transmitter?
May 22, 2017 · Hello, I have an S500 quadcopter with PixRacer running AC 3.4.6. The TX used is a FlySky FS-i6S which has the option for the throttle stick to be either normal or centered. So far I’ve done all my flight with the stick in normal position but as I mostly fly in PosHold or Loiter modes (and AltHold) taking video, I switched the TX throttle stick to be centered. The FlySky menu is already set ...
