Search results
People also ask
How do I program my SmartCode 913 lock?
Where can I find a Kwikset SmartCode 913 troubleshooting guide?
Does SmartCode 913 have auto lock?
How do I Reset my Kevo smart lock?
On my Smartcode Touchscreen, the batteries drain within one week. The Wireless Card LEDs are staying on. Remove the battery pack, press and hold the program button for 10 seconds.
- Ask a Question
The Kwikset Home. Security on the outside, convenience on...
- Ask a Question
View and Download Kwikset SmartCode 913 installation and user manual online. Tuochpad electronic deadbolt. SmartCode 913 locks pdf manual download.
One of the steps you can take to troubleshoot your Kwikset SmartCode 913 is to reset it. Also, if you've lost your code or want to remove all existing codes and add new codes, you'll...
- 4 min
- 2.5K
- Smart TechVille
- About The Mastercode
- Enabling and Setting The Mastercode
- Adding User Codes with The Mastercode Enabled
Using a Mastercode is an optional, added-security measure. It is not enabled by default. A Mastercode is used to add and delete user codes, but it cannot unlock the door (unless the same code is programmed as a user code, though this is not recommended). The Mastercode must be 4-8 digits.
Programming timeout: If no button is pressed for five seconds, the system will time out (indicated by three beeps and a red flashing keypad), and you will need to restart the procedure. 1. Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). 2. Enter new Mastercode. 3. Press Lock button once. 4. Re-ent...
The procedure for adding user codes is different when the Mastercode is enabled. For instuctions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock. 1. Keep door open. Press the Program button once. The keypad will flash green and you will hear three beeps. 2. Enter Mastercode. 3. ...
How do I program my SmartCode 913 lock? 1. Open the door. 2. Remove battery cover. 3. Press the program button once. 4. Enter new user code. 5. Press lock button. 6. If programming is successful the keypad will flash green once, and you will hear one beep.
Press Lock button once. If programming is successful, the keypad will flash green once with one beep. If programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure the user code is not a duplicate and that it is between 4 and 8 digits during your next attempt.
Perform a factory reset. A factory reset will delete all codes associated with the lock. 1. Make sure the door is open and unlocked. 2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep. 3. Press and release the program button.
