Search results
• Dry vacuum the area first, before spot cleaning with the SpotBot. • Some spots and spills require that you pick up the chunky debris with a rag or towel before you begin cleaning in the automatic or manual cycles. WARNING Keep spray away from face. Failure to do so may result in personal injury.
View and Download Bissell SpotBot 1200 Series user manual online. SpotBot 1200 Series vacuum cleaner pdf manual download. Also for: Spotbot 7887 series.
Place the unit directly over the spot or stain, making sure the stain is in the center of the cleaning area. 2. select which cleaning cycle (surface stain or set-in) you would like to use. spotbot will begin spraying, brushing and suctioning the soiled area, in a pre-programmed cycle. both cycles have been tested and proven to deliver superior
- 1MB
- 12
- Problem
- VACUUM MOTOR REPLACEMENT
- REPLACING THE MANIFOLD DUCT
- TROUBLESHOOTING THE TRIGGER VALVE
- Automatic Mode
No spray (both hose and floor) Unit will only spray out of the hose (no spray at floor in automatic) No/Low Suction Brushes do not spin Unit will only run in manual mode Unit will not run in manual mode Unit only runs in automatic mode Power indicator light comes on Continues to run in automatic even with hose removed from trigger valve. Possible c...
The vacuum motor can be replaced by removing three mounting screws. Note how the solution tube is routed underneath the motor duct after coming off the "T" connector. Also note how the solution tube from the receiver is routed around the screw boss before connecting to the pump. The small motor gasket may stick to the vacuum motor when you disassem...
The Manifold Duct is secured with two screws. Remove the two screws then pull up while wiggling the duct in order to release the snaps on the bottom. The gasket should be attached as shown.
The trigger valve allows the unit to operate in either automatic or manual mode depending on whether the wand is inserted or not. With the wand fully inserted into the trigger valve the unit should run and spray only in the automatic mode. The unit should only run in the manual mode with the wand removed from the trigger valve. The trigger valve ca...
If the wand is not inserted into the trigger valve the unit will not run in the automatic mode. If the wand is removed from the trigger valve while the unit is running in automatic mode the unit should shut off.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. There may be alternative versions of this product, please contact us should you require this information.
Place the unit directly over the spot or stain, making sure the stain is in the center of the handsfree cleaning area. 2. Select which cleaning cycle (surface stain or set-in) you would like to begin with. Your SpotBot will begin spraying, brushing and suctioning up the spots and stains, in its pre-programmed cycle. Both cycles have
People also ask
How do I use a spotbot?
How does a spotbot work?
What should I do before using the spotbot®?
How do you clean a spotbot?
How do you clean a water tank with a spotbot®?
How do I use a spotbot flex hose?
Shop OEM replacement parts by symptoms or model diagrams for your Bissell 1200 Spotbot!
