Search results
- To reset the router, you'll need to press this button (while the router is connected to power) and hold it down for about 10 seconds. After you release the button, the router will reset itself to the factory default settings, and then reboot.
www.howtogeek.com/131338/how-to-access-your-router-if-you-forget-the-password/
People also ask
How do I Reset my router to factory defaults?
How do I Reset my router password?
Why is my router's default username & password not working?
What is the default password to a router?
What if I forgot the username or password for a router?
Why can't I log in to my router?
Oct 9, 2022 · If you can't log in to your router because you forgot the password, consult the router's manual, look for a sticker on the router itself, and check RouterPasswords.com for the default password used by your router. Otherwise, you must factory reset your router to set a new password.
Jun 28, 2011 · Router Password Kracker is a free software to recover the lost password of your Router. It can also be used to recover password from your internet Modem or Web sites which are protected by HTTP BASIC Authentication.
Sep 27, 2021 · Need to access your router, but lost the password/username? We show you how to recover it, as well as instructions for port mapping without credentials.
Dec 10, 2023 · If the default username and password are not working, it probably was changed by you or your network administrator at some point. Most routers have a small pinhole button on the back or bottom (shown in the picture). Pressing and holding this button for 30 seconds hard resets the router.
- 363.9K
- Netgear: Power on your Netgear router and wait approximately one minute for the router to boot up. Locate the “Restore Factory Settings” button on your router, which is enclosed in a red circle and labeled accordingly.
- Linksys: Locate the “Reset” button on your Linksys router. The reset button is a small, circular button normally found on the back of the router and labeled accordingly in red ink.
- Belkin: Locate the “Reset” button on your Belkin router. The reset button is a small, circular button usually located on the back of the router and labeled accordingly.
- Link: Verify that your D-Link router is powered on. Press and hold the “Reset” button for about 10 seconds using a small, thin object such as the end of a paperclip or pen.
Method 1. Step 1: From a computer that is connected to the router (wired or wireless), Open your Internet browser and type the IP address of the router in the address bar. The default IP address is 192.168.0.1. At the login, enter the username (admin) and your password (default password is nothing).
Apr 18, 2024 · Step 1: Perform a hard reset on the router. Use a pin or pen to press and hold the reset button for 10-15 seconds. The power indicator will flash, and the other lights will come back on after 1-2 minutes. Step 2: Connect to the wireless name "ASUS" and access the router setup page.
