Search results
After the unit reaches the correct tempreture the blower shuts down but the heating element stays on. The only way I can shut it down is to turn off the breakers. Do you have ant idea what the problem is? The unit at this time also seems to put out less heat than normal. Should I replace the heating element along with any other switches? Thanks..
The water heater may also have an on/off switch located in the bathroom, especially in older mobile homes and it is often red and lights up when on. Another location for an on/off switch is mounted over the cover plate for the heating element at the side of the water heater, like in the photo below. If you have checked the circuit breaker in ...
- Step 1 - Troubleshooting
- Step 2 - Element Replacement
- Step 3 - Thermostat Problems
Find the switch that gives your water heater power, and shut it off. Use the screwdriver to remove the cover(s) (there are usually up to two) over the thermostats and elements. At this point, you should see plastic shields over the element connections – carefully snap these off. You need to be absolutely sure that you don't electrocute yourself, so...
Now it's time to begin replacing your heating element. First and foremost, turn off the power to your water heater to avoid electrocution. Drain all the water from its tank. If at this point, you find that your heating element is too corroded or in such bad condition that you can't remove it without damaging the water heater itself, then it might b...
If the heating element passed the meter probe test, then the problem with your water heater is most likely a malfunctioning upper or lower thermostat. Some mobile home water heaters will contain only one thermostat. That is perfectly normal. In order to test the thermostat, the first step is to remove its metal cover plate and check the status of t...
Model: GE Series. The purpose of this manual is twofold: one, to provide the installer with the basic directions and recommendations for the proper installation and adjustment of the water heater; and two, for the owner– operator, to explain the features, operation, safety precautions, maintenance and trouble shooting of the water heater.
- 402KB
- 20
May 13, 2023 · However, they are commonly found in one of the following locations: 1. Utility Closet. The utility closet is one of the most common places for a water heater in a mobile home. This closet is typically a small, separate area dedicated to housing the water heater and sometimes other utilities. It could be located in a hallway, kitchen, or bathroom.
Taking pictures is also a good idea. Nothing is more frustrating than trying to reinstall your heating element and not remembering where the wires go. Once the wiring is documented, remove the heating element or elements from the unit. Step 3: Remove the coils from the old heating element.
People also ask
How do I troubleshoot a mobile home furnace?
What if the burner in my standing-pilot furnace won't light?
Why does my mobile home furnace blower not come on?
Why is my Blend air unit beeping?
Slowly let the button up. If the pilot remains lit, turn the knob to ‘on’ If pilot goes out, wait 5 minutes and repeat steps c thru e. If the pilot does not light right away, you may have air in the line. Trying several times to light the pilot should eventually purge the air and allow the pilot to light.
