Yahoo Web Search

Search results

  1. Model: GE Series. The purpose of this manual is twofold: one, to provide the installer with the basic directions and recommendations for the proper installation and adjustment of the water heater; and two, for the owner– operator, to explain the features, operation, safety precautions, maintenance and trouble shooting of the water heater.

    • 402KB
    • 20
  2. May 23, 2020 · One cuts out at 125deg C cools and resets. The other permanently cuts out at 175degs C. It does not reset. 175deg stat does reset but its what's known as a 'self hold', when it trips it has an internal element that is connected that keeps it off until 240v is disconnected from heater, the stat itself can then cool down and resets automatically.

  3. A few years back our mobile home electric furnace started blowing cold air. We checked it and seen that it had burnt a wire inside. We replaced that wire with higher grade wire, and it burnt that wire also. Element is fine, blower is fine, fuses replaced, but it keeps burning the wire and causes the air to blow cold.

  4. For use only in road vehicles i.e. caravans and motorhomes only. Not suitable for caravan holiday homes i.e. mobile homes or static caravans. The Water Heater position must allow access for servicing and to the reset button. Whale’s policy is one of continuous improvement and we reserve the right to change specifications without prior notice. 2.

  5. Quick tip: issues isolated in the upper or lower heating elements have common signs. Lukewarm water is typically contributed to a defective upper heating element, while short spurts of hot water can be sourced back to the lower heating element. Thermostat. A lack of hot water can also be the result of a faulty thermostat. A typical electric ...

  6. Install and Program the New Thermostat. Once you have obtained the new thermostat for your mobile home, follow these step-by-step instructions to install and program it: Turn off the power to your HVAC system at the main circuit breaker. Remove the old thermostat from the wall by removing the screws holding it in place.

  7. People also ask

  8. Your heater is equipped with a manual-reset ther-mal overload protector. If heater fails to operate when thermostat is turned to its highest setting: 1)Turn off power at service entrance. 2)Remove knob and grille. 3)Press button marked “RESET”. This type of device is particularly useful (compared to automatic reset devices) because it ...

  1. People also search for