Search results
Parts Ordering Information If literature or replacement parts are required, con-tact the source from whom the machine was pur-chased or contact Alliance Laundry Systems at (920) 748-3950 for the name and address of the nearest authorized parts distributor. For technical assistance, call the number listed below: (920) 748-3121 Ripon, Wisconsin
- 6MB
- 192
Parts www.comlaundry.com Drying Tumblers 75 Pound Capacity Models Starting Serial No. 0904004427 Refer to Page 5 for Model Numbers TMB795C_70421901 10 20 40 30 50 60 0 10 5 PUSH TO START HEAT COOL DOWN HIGH TEMPERATURE LOW 15 0 Part No. 70421901R8 January 2012
- 4MB
- 142
parts distributor. For technical assistance, call (920) 748-3121. Wiring Diagram The wiring diagram is located in the literature packet supplied with all the non-European models. On European models, it is located in the junction box. The wiring diagram is inside the electrical junction boxes located on the back of 0300D models, or under
- 1MB
- 68
Parts Ordering Information If literature or replacement parts are required, con-tact the source from whom the machine was pur-chased or contact Alliance Laundry Systems at (920) 748-3950 for the name and address of the nearest authorized parts distributor. For technical assistance, call either of the num-bers listed below:
Disconnect gas line at lower pocket gas valve. Remove screws holding gas valve to gas valve bracket and remove valve. IMPORTANT: When reinstalling gas valve, purge air and sediment from gas service line before connecting to tumbler. Purge remaining air until odor of gas is detected, then tighten connection.
Parts www.alliancelaundry.com Drying Tumblers Stacked 30 Pound Capacity 15 Digit Model Numbers with 2 in 12th Position Refer to Page 5 for Model Numbers T477C_70304801 START 25C HIGH TEMP MED TEMP LOW TEMP NO HEAT 1 2 3 SELE CT TEMP INSERT COIN USH START 1 2 3 SELE CT EMP INSERT COIN USH STA RT STAR 25C HIGH MED TMP LOW TEMP NO HEAT Part No ...
When dryer is on the end of a line of equipment, extend header at least 4 feet beyond dryer. Install globe valve, union, check valve and bypass trap at end of line. If gravity returned to boiler, omit trap. Insulate steam supply and return line for safety of operator and safety while servicing dryer.
