Search results
41922R.S Main Control Board Replacement Instructions. These instructions are written assuming that you will have ample room around Opener to perform this repair. Some rare instances will require removal of the unit from it’s mounting hardware and repair made on a bench or floor.
View and Download Genie Alladin connect quick setup manual online. Alladin connect garage door opener pdf manual download.
Compatible with models: 2033, 3053, 3120, 3124, 3155, 3164, 4063, 4124, 4164, 7053, 7135, 7155 that have integrated Aladdin Connect ( only a compatible replacement for units that originally utilized green boards)
The wiring from the door control module connects with existing wires going to the wall control push button terminals. You can review the garage door opener manual to see which terminals are for the push button or just trace the wire from the push button to the opener.
Aladdin Connect RetroFit kit installation videos. View the whole video or by chapter of each step to help with installing Aladdin Connect.
INSTALLATION OF IGNITION CONTROL. Orient the control as close as possible to the orientation of the board being replaced. Align the plastic mounting feet with the mounting holes in the elec-tric panel and press on each corner of the control board to seat the mounting feet.
People also ask
How do I contact Aladdin connect technical support?
How do I install Aladdin connecttm (DCM) in the garage?
What garage door openers work with Aladdin connect?
How do I set up the Aladdin Connect® device?
How do you wire a garage door control module?
Does Genie Aladdin connect work with all garage door openers?
STEP 1 - The door control module must be installed where it can be seen and heard while standing under the garage door when it is open. Determine Mounting Location. There are 3 ways to mount the Door Control Module (DCM). The location must be within 5ft of a standard 110-volt AC power outlet. Mount next to opener near ceiling.
