Search results
Replace the entire blower motor or the blower control module attached to the blower motor. If you replace the blower control module go to Section B - Step 40. Always inspect failed
- 190KB
- 6
Page 34 Replacing the ECM Control Module (Model X13 & Endura Pro) ® ® Before replacing the electronic-control module, you must test the motor module to ensure it is not also damaged. Installing a new control on a failed motor will result in no operation, improper operation and/or potential failure of the new control.
Find OEM York S1-32440880007 Fan Motor with Control Module, Condenser, 208-230V, 682RPM, 1/3HP, ECM replacement part at Parts Town with fast same day shipping on all in-stock orders until 9pm ET.
- INSTALLATION
- INSTALLATION OF IGNITION CONTROL
- DIAGNOSTIC FAULT CODE STORAGE AND RETRIEVAL
The required number of steps to remove the failed ignition control and install the new ignition control will vary depending on the furnace model. However the wire connections will remain the same. Some models (certain upflow 90% models) will require that the sheet metal control box be replaced. The existing door switch and transformer will be re-us...
Orient the control as close as possible to the orientation of the board being replaced. Align the plastic mounting feet with the mounting holes in the elec-tric panel and press on each corner of the control board to seat the mounting feet. Apply only enough pressure to seat the mounting foot or the ignition control may be damaged. FIGURE 2: Board L...
The control in this furnace is equipped with memory that will store up to five error codes to allow a service technician to diagnose problems more easily. This memory will be retained even if power to the furnace is lost. This feature should only be used by a qualified service technician. The control stores up to five separate error codes. If more ...
Field Control Replacement Procedure Replacing ECM Control Module: To replace the control module for the GE variable speed indoor blower motor, you need to take the following steps. 1. You MUST have the correct replacement module. The controls are factory programmed for specifi c operating modes. Even though they look alike,
Jul 16, 2006 · PSE - Removal, Refit and Check and Turn over as required. The PSE (A-37) has a vacumn pump to operate the door, boot and petrol filler locks. It also controls the alarm (if fitted) and the interior light timer, door unlock crash sensor. Plus rear demister relay and ARA control model if fitted.
People also ask
How do I install the ECM motor?
Should I read the instruction manual before using the ECM motor simulator?
What is an ECM motor?
How do I install a new motor control?
To inspect the module, remove the wire harnesses and blower housing to get access to the motor and module. Remove the screws holding the module to the motor.
