Search results
Quick tip on starting an Eliminator waste oil heater from Aaladin.
- 6 min
- 10.6K
- Minh's Garage
Apr 4, 2020 · In this video I tell you everything you need to know about the Aladdin Greenhouse Heater. How to light it, change the wick, fuel it and where to get spare parts for cheap! If you want to find...
- 13 min
- 10.1K
- Gwenyn Gruffydd
Nov 8, 2019 · Restoration of the British-made Aladdin Blue Flame Heater / Camp kerosene stove. The heater / stove in general is in good condition. It is also very dirty and rusting parts.
- 23 min
- 330.2K
- Restomaniac
Aladdin Kerosene Heater Instructions. Aladdin portable kerosene heaters radiate heat to an area of approximately 15 by 20 feet. The heaters are designed to operate strictly on kerosene and produce heat for approximately 10 to 14 hours, depending on which model you have.
- Peter Timm
- Power Indicator Light Isn’T on
- Base Doesn’T Heat
- Base Doesn’T Finish Heating Up
- Activator Won’T Run
- “Base Will Not Heat” Led Is Lit
- Activator Stops Suddenly and The Power Led Goes Out
- Activator Top Is Too Hot (Over 200° F) and Shuts Off
- “Ht9” Isn’T displayed For Correct Cycle Time
- “Base Will Not Heat” Led Immediately Illuminates After Inserting The Base
- Base Temperature Is Low
Main power is off -Turn on the main power.Power cord isn’t plugged in -Plug in the unit.Main fuse is blown -Call an authorized service tech.Power outage -Check locally for power outage confirmation.Base is positioned incorrectly -Reposition the base so it’s snugly against the alignment fixture.Broken switch -Call an authorized service technician.Base is positioned incorrectly -Remove the base and reposition a new base so it’s snugly against the alignment fixture. If the activator still doesn’t work, call an authorized service technician.
Voltage is incorrect -Have voltage checked.Interrupted power -Reset the unit by turning it off for 10 seconds then back on.Base is positioned incorrectly - Reposition the base so it’s snug.Base is in the pellet guide when the unit is powered up -Remove base from pellet guide prior to initial power up.Base is too hot so the heating cycle won’t start -Don’t heat the base more than once during a single meal period.
Activator has experienced 3 errors consecutively and has powered down -Check that the base isn’t in the centering guide, then turn the unit back on.Power cord is unplugged -Plug in the power cord.Power outage -Check locally for power outage confirmation. Reset the activator by turning it off for 10 seconds then back on. Contact an authorized service technician if the activator still doesn’t...Air filter is missing -Replace the filter.Dirty air filter - Clean the air filter at least once a month.Air flow is blocked -Check for and remove obstructions in the intake and/or rear exit panel.Base has been heated within the past hour and is still hot -Use a room temperature base.Previous base was pulled out before the cycle finished -Keep the base in alignment guide for the whole heating cycle.Base has been heated within the past hour and is still hot -Use a room temperature base.Base is no longer usable -Base will need to be replaced.Measuring base temperature is in the wrong location -Check the temperature.Measurement device error -Have it checked by an authorized service technician.View & download of more than 91 Aladdin PDF user manuals, service manuals, operating guides. Lighting Equipment, Heater user manuals, operating guides & specifications.
When the flame shows any yellow the wick is too high or too low or something is wrong with the heater; never let the heater burn like this. This visual safety indicator is so important and so simple to use that a little practice at first will amply repay you.
