Search results
ENTERING YOUR COMBINATION. STEP 1: Turn the dial three times to the right, then stop when the first number lines up with the indicator. STEP 2: Turn the dial ONE full turn to the left, passing the first number, and stop when the second number lines up with the indicator. STEP 3: Turn the dial to the right and stop when the third number lines up ...
ENTERING YOUR COMBINATION. STEP 1: Turn the dial three times to the right, then stop when the first number lines up with the indicator. STEP 2: Turn the dial ONE full turn to the left, passing the first number, and stop when the second number lines up with the indicator. STEP 3: Turn the dial to the right and stop when the third number lines up ...
USER INSTRUCTIONS Zenith Digital Combination Locks ... Video To Lock To Unlock ENTER CODE ... time-out after 4 seconds. Unfinished instructions will time-out after 4 ...
With latch still in the open position, SLIDE square button in towards numbered dials and HOLD it in this position. While holding the button, set each numbered dial one at a time. Roll numbered dial down until you reach your desired 3 digit combination. Make sure the digits are centered across the middle of the lock assembly. With latch still in ...
with the RED triangle on the lock case. A slight resistance can be felt. The code tool is no longer required. Set your personal Code and make a note Turn the knob back to the closed position. The programming pin returns back to the initial position. Open and close the lock. The Code is ‘scrambled’. Lock is closed and the personal Code is saved
Oct 5, 2017 · New Prestolocks have a factory set combination of "0-0-0." Turn the shackle 180 degrees. Press the shackle down and turn it 90 degrees to the left or right. Input the new combination. Move the shackle 90 degrees so that it is 180 degrees from its locked position. Take your hand off the shackle and pull it out. Turn it back to the locked position.
Enter the combination and pull the shackle to open. If this is a factory-new lock, the combination is 0-0-0-0. Turn Shackle 90° to position 1. Push shackle in to lock until it clicks. Turn shackle another 90° to position 2. Set dials at indicator line to desired combination. Pull shackle up.
