Search results
Perform a hard reset by following the steps below: Power off your device and wait a few seconds. Press and hold Volume Up + Power buttons together until recovery mode screen appears. (These button combinations can change on different modals.) When you see the device logo release the Power button, but keep holding Volume Up until the recovery ...
Restore from the options of BlackBerry DTEK50. If you want to make a reset using the device options to return to the factory state a BlackBerry DTEK50 you have to follow these simple steps: Estimated time: 5 minutes. If you cannot turn on the BlackBerry DTEK50 and therefore you cannot perform the factory restore from the device settings, this ...
- 1 min
- 33
A notification appears when you insert the media card into your device. Make sure that you are connected to the Internet, and then tap the notification to download the driver. Page 60 User Guide Settings Pull out the tray completely and remove the media card. Push the tray back into the slot.
Tap Next. If necessary, type the server address found in your activation email and tap Next. If necessary, type your username. Type your activation password and tap Activate My Device. If your activation password is expired, create a new password in BlackBerry UEM Self-Service or contact your administrator.
User Guide Getting started Getting started Inserting the SIM card, battery, and media card Remove the battery door Tip: The battery door is flexible and may bend when you remove it. To remove the battery door, pull up the bottom of the battery door. Insert or remove the SIM card Do one of the following: •...
Page 6: Insert A Media Card. Setup and basics User guide 4. Put the SIM card in the tray. BBE100-2 Single SIM version BBE100-5 Dual SIM version 5. Push the tray back into the slot. Insert a media card If you want more storage for pictures, videos, music, and documents, you can insert a media card (microSD card).
Page 4: Charging The Battery. charging the battery Connect the battery charger to your phone and power source respectively, the LED indicator will light while charging. Tip: To reduce power consumption and energy waste, when the battery is fully charged, disconnect your charger; switch off Wi-Fi, GPS, Bluetooth or background-running ...
