Search results
- Add a user: System/Partition master code + + new user number + new user code
help.adt.com/s/article/Change-Panel-Codes
People also ask
How do I add user codes when the mastercode is disabled?
How do I disable a mastercode?
Why do I need a mastercode?
How do I change the mastercode?
For instructions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock. 1. Keep door open. Press the Program button once. The Checkmark will flash five times and you will hear five beeps. 2. Press Checkmark symbol once. 3. Enter Mastercode.
To add user codes with the Mastercode enabled, follow these steps: 1. Keep the door open and press the Program button once. The keypad will flash green and you will hear three beeps. 2. Enter the Mastercode. 3. Press the Lock button once. 4. Press the Program button the number of times that corresponds to the user code position being programmed.
Adding User Codes with the Mastercode Enabled. The procedure for adding user codes is different when the Mastercode is enabled. For instuctions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock. Keep door open.
- 2 Troubleshooting: Installation
- 3 Troubleshooting: Door Jamming and Door Handing
- Keypad error test
- What type of batteries do you recommend?
- I am planning to be away for several months. Will my lock operate when I get back?
The interior mounting screws are difi cult to tighten. The interior and exterior assembly won’t mount parallel to the door edge. The interior assembly does not fi t on the mounting plate. If you encounter any of the problems above, the deadbolt latch may be installed upside down. Remove the interior assembly, mounting plate, and exterior assembly ...
The lock jams and the turnpiece does not rotate smoothly. The lock beeps, the keypad fl ashes red, and the door cannot lock. The door handing process was not executed during installation. Perform the door handing process in the Installation Guide. The hole in the door is misaligned. Disassemble the lock, and reinstall it without the adapter ring on...
Install a fresh set of batteries and turn switch #3 to the ON position. Test each button on the keypad (one at a time) and listen for a beep on each button press. If beeping is not heard on all buttons, contact Technical Support for further troubleshooting. The Lock button does not lock the door. No user codes are programmed. If there are no codes ...
For best results, use new non-rechargeable Alkaline batteries only.
When the system is idling, it consumes minimum power (very close to battery shelf life.) With alkaline batteries, the lock should be operable after years of idle. I replaced my batteries less than a year ago and need to replace them again. Check your door alignment. If the deadbolt makes several unsuccessful attempts to lock or unlock the door, it ...
- 1MB
- 15
1. Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). 2. Enter new Mastercode. 3. Press Lock button once. 4. Re-enter Mastercode. 5. Press Lock button once. If programming is successful, the keypad will flash green once with one beep.
- 4MB
- 18
r codes is different when the Mastercode is enabled. For instuctions on how to add user codes when the Mastercode is disabled, see the . ns. allation and Us. r Guide that came with your lo. w. ll flash five times and. 4. Press Lock symbol once. he. kmark will illuminate and yo. w. 2. Press Checkmark symbol once. 5. Enter new user code.
The procedure for adding user codes is different when the Mastercode is enabled. For instuctions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock.
