Search results
May 2, 2024 · Kwikset SmartCode 913 keypad light is not working. If your keypad light doesn’t work, it could be because of one of the following reasons: Check the battery. Please make sure they are fresh and inserted correctly. The lock will not work with dead batteries or improperly inserted batteries. Make sure your keypad is not damaged.
Press Lock button once7. Press “9” six times.8. Press Lock button once.If programming is successful, the keypad will flash green once with one beep.If programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure to enter a valid Mastercode in step 3 during your next attempt9.
People also ask
Why is my 913 keypad not working?
Why is my Kwikset SmartCode 913 keypad light not working?
Why is my Kwikset lock keypad not working?
Why is my SmartCode 913 lock button not working?
Oct 16, 2022 · Follow the steps below to perform the door handing detection on your Kwikset SmartCode 913: Keep your door open and the latch extended. Remove the interior cover and remove the battery pack. Check that the batteries are correctly installed in the battery pack. Press and hold the Lock button on the keypad. Keep holding the button.
Feb 1, 2024 · To reset your lock code on the SmartCode 913, follow these steps: Keep the door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). Enter a new Mastercode. Make sure to avoid timeouts by completing each step within 5 seconds.
May 8, 2023 · Restart the Lock. If your Kwikset Lock keypad stops working, restarting the lock could do the trick. To restart your Kwikset Lock, remove the batteries from the lock. Then wait 20-30 seconds and put the batteries back in. Ensure that the batteries are well placed when putting them back. If the keypad doesn’t work after this, continue to the ...
Install exterior keypad and mounting plate. Diameter is 2-1/8" Diameter is 1-1/2" Support exterior assembly during (54 mm) (38 mm) mounting plate installation. 2-1/8" 1-1/2"... Page 3 Mastercode For enhanced security, a mastercode may be used when adding and deleting user codes.
