Factory Reset iPhone and iPad without iTunes to Recover Boot Loop or White Apple Logo, etc. Recover All Kinds of iPhone Booting Failure without iTunes, Easy and Safe Solution.
- Enter/Exit Recovery Mode
One Click to Enter or Exit
Data will Not be Affected
- Bypass Stuck Apple Logo
Solve All Apple Logo Issues
Stuck/Flash/Loop/Frozen Apple Logo
- Stuck Recovery Mode
Enter/Exit Recovery Mode with Ease
Just 3 Steps, No Skills Needed
- Solve iOS Error 4013
Settle Various iTunes Error Code
Including Error 4013/4014, and etc
- Enter/Exit Recovery Mode
Search results
Feb 5, 2024 · If you want to enable the Master Code on your Kwikset SmartCode 909, here are the steps to follow: Ensure the door is open. Long-press the Program button on your lock (for about 5 seconds) until the keypad flashes green. Enter a Master Code (4 or 8 digits) and press the Lock button on the keypad.
Perform a factory reset. This procedure will delete all User Codes associated with the lock, and the default Programming Code (0-0-0-0) and User Code (1-2-3-4) will be restored. 1. Make sure the door is open and unlocked. Press and hold the Reset button for 5 seconds, until you hear 3 long beeps. 2. Enter the default Programming Code (O-O-O-0). 3.
Step 4: In case of a Kwikset 917 and 955 you will need to use a paper clip or a pin to access the program button. Step 5: Wait for 20 to 30 seconds until you hear a beep or two. Step 6: Afterward, the lock will flash red, now press it again. If the deadbolt starts to re-hand, your Kwikset smart code reset is complete.
1. Remove battery pack. 2. Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. 3. Press the Program button once more. The status LED will flash green and red several times. 4.
May 25, 2024 · Three incorrect codes are entered within one minute. After a 60-second keypad lockout, you must re-enter the code. Kwikset SmartCode Deadbolt Reset. You can reset your Kwikset SmartCode Deadbolt for the first time when you encounter any of these issues: To reset your Kwikset SmartCode Deadbolt: Make sure the door is open and unlocked.
Perform a factory reset. A factory reset will delete all codes associated with the lock. 1. Make sure the door is open and unlocked. 2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep. 3. Press and release the program button.
Mar 1, 2023 · Factory reset SmartCode 916. A factory reset will delete all user codes associated with the lock and will remove itself from your smart home system. Please only perform a factory reset when the primary controller is missing or inoperable. To perform a factory reset, please perform the following: 1. Remove the battery pack 2.
