Search results
Step 1 Battery. Before working on the phone, be sure that the device is turned off. Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off. Add a comment.
This video shows how to insert and remove the SIM Cards on the Blackberry DTEK 60 smart phone, we show how to change both of the nano sim cards. If you like ...
- 4 min
- 6K
- HowTechs
Step 1 Battery. Turn the device upside down. Using your finger, slide the silver cover release button towards the top of the device. Lift and remove the back cover. Add a comment.
Jan 10, 2010 · My suggestion is to unlock it and then sell the phone on kijiji or craigslist or even here in the Market. You will get more for it due the fact it is unlocked and more people will be interested in it. Then use that $ towards a phone with Bell. 10-06-10 02:06 PM.
Step 3 SIM Card. Push and slide the bottom-most metal SIM card cover to the left and up to unlock it. Remove the SIM card. Insert a replacement SIM card, if needed. Add a comment.
Perform a hard reset by following the steps below: Power off your device and wait a few seconds. Press and hold Volume Up + Power buttons together until recovery mode screen appears. (These button combinations can change on different modals.) When you see the device logo release the Power button, but keep holding Volume Up until the recovery ...
Step 4. Remove the screws. You will need to remove the ten small screws that hold the back of the phone together. Start by using a T5 phillips screw driver to remove the four 4.5 mm screws on the outside corners of the phone. Next, use a T4 phillips screw driver to remove the four 4mm screws on the sides of the device.
