Search results
1. Manually put the bolt in the extended (lock) position. Press the PROGRAM button once, enter your new 4 - 8 digit code and then press the LOCK button. 2. Press the PROGRAM button twice, enter the same or a new code and then press the LOCK button once. If your old code still remains in the unit, you will need to perform a hard reset of the ...
Jun 11, 2021 · Follow these simple reset steps: Ensure the door with the Kwikset 888 SmartCode deadbolt with Z-Wave or 913/914 SmartCode is open and unlocked. Then go ahead and remove the battery pack. Press and hold the program button (this should be on the interior back panel of the lock) while re-inserting the battery pack.
Perform a factory reset A factory reset will delete all codes associated with the lock. 1. Remove battery pack. 2. Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. 3. Press the Program button once more.
Learn how to factory reset your Kwikset Smartcode 914 lock with this easy video tutorial. Compare with other models and get a deal on Amazon.
- 2 min
- 303.2K
- The Smart Home Helper
A factory reset will delete all codes associated with the lock. 1. Make sure the door is open and unlocked. 2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep. 3. Press and release the program button. You will hear one short beep.
Factory Reset should be used when you want to change the lock owner, have lost your phone, or are troubleshooting a new installation. Before you begin the Factory Reset process: Delete the lock from the home within the Kwikset app, and remove the lock from your phone’s Bluetooth list by tapping Forget Device in Bluetooth settings. Factory Reset.
2. Press Lock button once. 3. Enter Mastercode 4. Press Lock button once 5. Press “9” six times. 6. Press Lock button once 7. Press “9” six times. 8. Press Lock button once. If programming is successful, the keypad will flash green once with one beep. If programming is unsuccessful, the keypad will fl ash red three times with three beeps.
