Search results
4 days ago · To perform a backup via Time Machine, follow the steps mentioned below: Click on the Time Machine symbol in the top toolbar and select "Open Time Machine Preferences". Click "Select Backup Disk". Now select your external drive and click "Use Disk". Method 2: Back up MacBook Air with iCloud.
5 days ago · Follow the steps below to factory reset Windows using the "Reset This PC" option. Step 1. Go to Settings on your PC, then click "Update & Security". Step 2. Navigate to the "Recovery" section and click the "Get Started" button under "Reset this PC". Step 3.
4 days ago · The IP phone should now be ready for use with the new IP phone firmware installed. The firmware can be verified by going to the phone Settings / Model Information menu option, where the load file installed is shown: This article explained how to perform a factory reset for Cisco IP phones 7975, 7965 & 7945 models.
5 days ago · Here are the steps on how to remove Remote Management from iPhone/iPad without password. Step 1. Select the Bypass MDM mode first on the main interface after you download the program on your computer. Step 2. Connect your device to the PC via USB cable.
4 days ago · Reset to default Manually. Log on to the computer with the affected user's profile. Close all Civil 3D and AutoCAD sessions. On the Windows Start menu, click Run. In the Run dialog box, enter Regedit. In the Registry Editor, browse to the registry key that corresponds to the affected software version. Refer to the table below.
3 days ago · In the following, I'm going to talk about the 5 ways to fix the favorites that disappeared from Safari on iPhone. #1. Retrieve Favorites on iPhone with iCloud Backup File (Available but not recommended) #2. Get Back after iPhone Bookmarks Gone using iTunes Backup File (Available but not recommended) #3.
2 days ago · Hello, To factory reset your ATEM MINI Extreme ISO (I did it last week), remove the power, press and maintain the upper left button (ON MIC 1), put the power, and wait until the upper left button is blinking. Connect your computer using USB, launch ATEM Setup, which will detect an "unknown switcher". In ATEM Setup, Click on the left button to ...
