Search results
Note: The lock will time out after five seconds. Disabling and Deleting the Mastercode. 1. Keep door open. Press and HOLD the Program button until the keypad Flashes green (about 5 seconds). 2. Press Lock button once. 3. Enter Mastercode.
Remove the battery pack from the lock. Press the "Program" button for 5 seconds and then the "A" button for 5 seconds. If TS (touchscreen controller) shows low battery trouble for the lock subjected to the firmware update then install new batteries in pack. Replace the battery pack into the lock.
Press the "Program" button momentarily. After several seconds, the lock will flash the status LED red and green several times and beeps twice (if audio is enabled) to indicate factory reset is complete. For model 910 or 914, perform handing on the lock. For model 916, it will automatically perform handing.
What Happens If I Forget My User Code for my SmartCode? You can make guesses, but each three consecutive failed attempts will result in the keypad/touchscreen locking out for 60 seconds. If you forgot your user code, there are two options: 1. Add new user codes.
How do I enable/delete the mastercode on my Smartcode? Enabling and Setting the MastercodeProgramming timeout: If no button is pressed for five seconds, the system will time out and you will need to restart the procedure.1. Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds).2. Enter new Mastercode.3.
For use on exterior doors where keyed entry and security is needed. Featuring SmartKey Security™, which protects against advanced break-in techniques and allows you to re-key your lock yourself in seconds. SmartKey Security™ re-key technology is compatible with Kwikset (KW1) keyway or (SC1) keyway options. Comes with 2 keys.
For instructions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock. 1. Keep door open. Press the Program button once. The Checkmark will flash five times and you will hear five beeps. 2. Press Checkmark symbol once. 3. Enter Mastercode.
