Search results
Jul 2, 2021 · Make sure your smartphone or computer is connected to the extender’s Wi-Fi. The default network name is TP-Link_Extender or TP-Link_Extender_2.4GHz/5GHz. If your extender has an Ethernet port, connect your computer to the extender via an Ethernet cable, then try again.
Nov 22, 2023 · Go to Settings > Wireless > Extended Network. Tap Extended Network name/password to change, or Copy Host SSID. The value is case-sensitive. Click Save. NOTE: If you change the wireless settings via a wireless device, you will be disconnected after the settings are applied. Please write down the new SSID for future use.
Jun 16, 2019 · Locate the pinhole on the side where the reset button is. Insert a pin then press and hold the reset button until all indicator lights turn on momentarily. The range extender should now be reset to factory default settings. Hope this will help you to reset the TP-link extender.
Method 1: Directly press and hold the reset button on the rear panel with a solid pin for approximately 8 to 10 seconds when the device is powered on. If you can see all the lights flashing, then go off and some lights go back on slowly, that means the device has been reset successfully. Method 2:
Make sure your smartphone or computer is connected to the extender’s Wi-Fi. The default network name is TP-Link_Extender or TP-Link_Extender_2.4GHz/5GHz. If your extender has an Ethernet port, connect your computer to the extender via an Ethernet cable, then try again.
Jun 28, 2022 · During the configuration of the range extender, if you cannot find your host Wi-Fi network, refer here to do troubleshooting; 4. Either keep the default SSIDs (network names) or customize them for the extended networks, and then click Next. If your web GUI is different please click here. 5. Verify your wireless settings and click Save. The ...
Jun 13, 2022 · Directly press and hold the RESET button on the rear panel/panel layout with a pin for approximately 6 to 10 seconds when the device is running.Release the reset button and wait for the device to reboot. If you can see all the lights flashing, then go off and some lights go back on slowly during the process, that means the device has been reset ...
