Yahoo Web Search

  1. Factory Reset iPhone and iPad without iTunes to Recover Boot Loop or White Apple Logo, etc. Recover All Kinds of iPhone Booting Failure without iTunes, Easy and Safe Solution.

Search results

      • Remove battery pack. 2. Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. 3. Press the Program button once more. The status LED will flash green and red several times.
      www.kwikset.com/support/answers/how-to-restore-default-settings-on-my-smartcode-touchscreen-perform-a-factory-reset
  1. People also ask

  2. One of the steps you can take to troubleshoot your Kwikset SmartCode 913 is to reset it. Also, if you've lost your code or want to remove all existing codes and add new codes, you'll ...more.

    • 4 min
    • 1894
    • Smart TechVille
  3. Perform a factory reset. A factory reset will delete all codes associated with the lock. 1. Remove battery pack. 2. Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. 3.

  4. On my Smartcode Touchscreen, the batteries drain within one week. The Wireless Card LEDs are staying on. Remove the battery pack, press and hold the program button for 10 seconds. Replace the battery pack. If the Wireless Card LEDs continue to stay on, contact Technical Support. Read More

  5. Feb 1, 2024 · How can I reset my lock code on the SmartCode 913? To reset your lock code on the SmartCode 913, follow these steps: Keep the door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). Enter a new Mastercode. Make sure to avoid timeouts by completing each step within 5 seconds.

    • About The Mastercode
    • Enabling and Setting The Mastercode
    • Adding User Codes with The Mastercode Enabled

    Using a Mastercode is an optional, added-security measure. It is not enabled by default. A Mastercode is used to add and delete user codes, but it cannot unlock the door (unless the same code is programmed as a user code, though this is not recommended). The Mastercode must be 4-8 digits.

    Programming timeout: If no button is pressed for five seconds, the system will time out (indicated by three beeps and a red flashing keypad), and you will need to restart the procedure. 1. Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). 2. Enter new Mastercode. 3. Press Lock button once. 4. Re-ent...

    The procedure for adding user codes is different when the Mastercode is enabled. For instuctions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock. 1. Keep door open. Press the Program button once. The keypad will flash green and you will hear three beeps. 2. Enter Mastercode. 3. ...

  6. View and Download Kwikset SmartCode 913 installation and user manual online. Tuochpad electronic deadbolt. SmartCode 913 locks pdf manual download.

  7. Perform a factory reset. A factory reset will delete all codes associated with the lock. 1. Make sure the door is open and unlocked. 2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep. 3. Press and release the program button.

  1. People also search for