Search results
4 days ago · 2. Perform a soft reset: Press and hold the power button and volume down button simultaneously for about 10-20 seconds until the device restarts. This can help resolve minor software glitches. 3. Boot into recovery mode: Depending on your Android device, the key combination to enter recovery mode may vary. Once in recovery mode, use the volume ...
5 days ago · Re: Connecting Atem mini via wifi. Keep in mind that the Atem control protocol is not WIFI friendly. If the Wifi connection is not 100% rock stable the atem will disconnect and a lot of issues will appear.. Hardwired ethernet is ALWAYS recommended.
4 days ago · Step 1: Shut Down and Restart. Restart your laptop by holding the power button until it turns off. Then, power it back on and immediately press the F12 key repeatedly until you see the Boot Menu. This step ensures you can access the advanced startup options, which are crucial for a factory reset without a password.
5 days ago · Just trying the latest version (16 Beta) for the first time on my laptop and this didn't seem to be explicitly stated in the FAQs or anywhere, but I found that Resolve will only launch if I am connected to the internet. At work, I am only able to connect my personal laptop to the guest Wifi, and since it's unsecured, I'd rather not have an ...
6 days ago · ATEM setup. IP:192.168.0.240. Subnet: 255.255.255.0. Router: 192.168.0.1. Laptop (wired) IP:192.168.0.2. Subnet: 255.255.255.0. Router: 192.168.0.1. Laptop / iPad (WiFi) DHCP (after doing an ipconfig - it showed an IP of 169.xxx.xxx.xxx - can't remember exactly and I'm now at work!) Do I need to manually configure the WiFi settings on my router?
4 days ago · sudo nmcli con up wifibridge Copy. 6. You can check that the Wi-Fi bridge is active from your Pi by using the following command. nmcli con show Copy. This command will show you a list of connections on your Pi. You should see a connection labeled “ wifibridge ” and that it is using the “ eth0 ” device.
5 days ago · Converted to install Apps on the Blackberry. To install the Apps with the BAR Format on your Blackberry, you need the free program "DDPB". This allows you to here download. Open the program "DDPB". On the left side you will see two input fields for IP address and password. Enter in the upper field of your "developer IP address".
