Search results
Page 3 Mastercode For enhanced security, a mastercode may be used when adding and deleting user codes. For more information about the mastercode, download the Programming and Troubleshooting Guide on the SmartCode 913 page at www.kwikset.com. Test the lock (review normal operation) Confirm that the code(s) added in previous step can unlock the ...
A factory reset will delete all codes associated with the lock. 1. Make sure the door is open and unlocked. 2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep. 3. Press and release the program button. You will hear one short beep.
Oct 22, 2019 · Kwikset SmartCode Locks ResetHome Automation https://www.systronicsrf.com/FeaturesDesigned for Everyone https://www.systronicsrf.com/system-features/designed...
- 1 min
- 199.9K
- Home Automation by SystronicsRF
Perform a factory reset A factory reset will delete all codes associated with the lock. 1. Remove battery pack. 2. Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. 3. Press the Program button once more.
Jun 11, 2021 · Follow these simple reset steps: Ensure the door with the Kwikset 888 SmartCode deadbolt with Z-Wave or 913/914 SmartCode is open and unlocked. Then go ahead and remove the battery pack. Press and hold the program button (this should be on the interior back panel of the lock) while re-inserting the battery pack.
Note: The lock will time out after five seconds. Disabling and Deleting the Mastercode. 1. Keep door open. Press and HOLD the Program button until the keypad Flashes green (about 5 seconds). 2. Press Lock button once. 3. Enter Mastercode.
It is an added security feature that is used to set up all functions. The default Programming Code is 0-0-0-0. It is recommended that you change it to a code of your own. 1. Make sure the lock is unlocked and the door is open. 2. Enter your Programming Code - for new installation, default is 0-0-0-0. 3. Press enter arrow. You will hear one beep ...
